The Installation of Fire Pumps – Better Technology CO., LTD.
The installation of fire pumps needs to pay more attention to many aspects. Different fire pumps have different types of installation requirements. What kind of installation is the most correct choice for fire pumps? What are the installation methods of the fire pump? For the fire pump installation problem, let us talk about it today.
First, Hard connection installation
Because the vibration of the fire pump is very small, the fire pump bottom plate can be directly installed on the precast cement foundation, which can meet the requirements and is suitable for most occasions. Anti-vibration installation: In general hotels, office buildings and special required places, anti-vibration installation can be used. That is, a connecting plate is placed under the pump bottom plate, then placed on four vibration-proof devices, and then bolted to the cement foundation.
Second, Install according to the selected fire pump model
According to the installation specifications of the fire pump installation instructions and methods, prepare the anchor bolts, flat washers, spring washers, nuts, etc., and prepare the cement foundation according to the installation method, and pre-bury the anchor bolts. After the foundation dried, clean the debris and dust on the foundation mounting surface, and check the horizontality of the foundation mounting surface with a flat ruler.
Third, Pay attention to the inlet and outlet pipes of the pump
For the convenience of maintenance and safety of use, it is required to install a regulating valve on each of the inlet and outlet pipes. It is better to install a pressure gauge near the pump outlet to adjust and ensure that the fire pump operates within the rated flow and lift range to ensure the normal operation of the pump. Run and grow the life of the fire pump.
Four, Correctly remove oil and dirt from the floor of the fire pump.
According to the requirements of the installation drawing, lift the pump to the basic installation position, find the direction of the inlet and outlet, place the washers, spring washers on the bolts, and tighten the nuts.